Red Hat ENTERPRISE LINUX WS 2.1 - Guide d'installation télécharger pdf (Page 26)

2.3.2 If your PC controls a spectrometer:

1. Be sure that the spectrometer is booted (see chapter 9.3.2 and 12.3.1.7)

2. Open a dataset

•Type new and create a new dataset.

• You can also select a dataset (e.g. exam1d_1H) acquired with another T

OP-

PIN or XWIN-NMR version

3. Enter cf (The command cf now configures the software according to the

hardware of your spectrometer.)

a) A window will appear:

Password request. Please enter the NMR ADMINISTRATION

PASSWORD

Type in the NMR ADMINISTRATION PASSWORD. Click OK.

b) A window will appear:

Spectrometer configuration: ...

Select your previous configuration and press Edit to confirm this configura-

tion.

c) A window will appear:

Edit configuration. ...

The selected configuration is displayed. Choose whether to configure it as a

spectrometer or datastation. Choose the type of your spectrometer e.g.

AVANCE → ENTER. Check or type in the 1H frequency of the magnet e.g.

500.13 → ENTER. Use the debug mode only in case of troubleshooting.

d) In case the information window mod hconfserver appears:

• your spectrometer has not a BSMS rack with ECLB board: you may

ignore this warning → ENTER. Nevertheless please check the config-

uration summary (uxnmr.info file) if all units are listed.

• your spectrometer has a BSMS rack with ECLB board and the DHCP

server might not work correctly. For troubleshooting information see

chapter 12.3.2

e) A window will appear:

Specify the channel to which external devices are con-

nected. The RS232/485 channel for external devices-Table

appears.

Check if the tty-numbers of the hardware components are set correctly.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 271 272

Pas de commentaire

Red Hat ENTERPRISE LINUX WS 2.1 - Guide d'installation Page 26