Red Hat DIRECTORY SERVER 2.0 - GATEWAY Manuel d'utilisateur télécharger pdf (Page 4)

Activating the Gateway

4 Red Hat Directory Server DSML Gateway • February 2005

2. Install Directory Server.

The DSML gateway is installed with Directory Server. It must be activated

separately; see step 3. The DSML Gateway can run simultaneously with the other two

gateways that are installed with Directory Server; however, it does not interact with

them.

3. Enable the the gateway.

See “Activating the Gateway” for instructions on how to enable the gateway and for

the command-line utilities available.

4. Modify the configuration files.

During installation, the files relevant to the DSML gateway are placed in

serverRoot/clients/dsmlgw. The configuration information is stored in

dsmlgw.cfg. You can modify desired settings in the file and customize the

application to suit your organization.

The gateway connects to the default port (

389) of Directory Server. The gateway can

also point to a different server and port; you can configure this at installation or when

moving or creating instances of the gateway. This is addressed in “Configuring the

DSML Gateway.”

DSML gateway can be configured to point to the Directory Server or the Admin

Server, to run from a different port, and to allow read-write access. The default

settings allow read-only access to the directory with the server set as the Directory

Server. See “Configuring the DSML Gateway” for detailed information on

configuration parameters. It is recommended that you not change the default settings.

Activating the Gateway

The DSML gateway is installed with Directory Server. To enable it, do the following:

1. Stop the server with the ./stop-admin command.

2. Run the activation script to enable the gateway:

./slapd-serverID/dsml-activate.extension -i

where

extension is either .bat, for Windows systems, or .pl, for all others. -i

initializes the gateway.

Running this script changes the

jvm12.conf, obj.conf, and server.xml files in

the

/admin-serv/config directory.

3. Restart the Admin Server with the ./start-admin command.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Red Hat DIRECTORY SERVER 2.0 - GATEWAY Manuel d'utilisateur Page 4