Red Hat NETSCAPE DIRECTORY SERVER 6.2 - GATEWAY CUSTOMIZATION Guide d'installation télécharger pdf (Page 69)

Chapter 5

Post Installation

This chapter describes the post-installation procedures for launching the online

help and populating the directory tree.

This chapter has the following sections:

• Launching the Help System (page 69)

• Populating the Directory Tree (page 70)

Launching the Help System

The help system for Directory Server is dependent upon Netscape Administration

Server. If you are running Directory Server Console on a machine remote to

Administration Server, you will need to confirm authorizations on Administration

Server.

Client IP address authorized on Administration Server. The machine running

Directory Server Console needs access to Administration Server. Configure

Administration Server to accept the client machine’s IP address in Administration

Server:

1. Launch Administration Server Console. The console should be running on the

same machine as Administration Server.

2. Click the Configuration tab, then click the Network tab.

3. In the Connection Restrictions Settings, select “IP Addresses to Allow” from

the pull down menu. Click Edit.

4. Edit the IP Addresses field to the following: *.*.*.*

This allows all clients access to Administration Server.

install.book Page 69 Wednesday, November 24, 2004 11:30 AM

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 123 124

Pas de commentaire

Red Hat NETSCAPE DIRECTORY SERVER 6.2 - GATEWAY CUSTOMIZATION Guide d'installation Page 69