Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Manuel d'utilisateur télécharger pdf (Page 45)

Figure 16 - DLPAR change window

Change the assigned Memory from 4 to 2 , then select ok

You should see the amount of memory assigned to the LPAR on the main screen change

from the 4 to the newly assigned 2 in a few moments.

Configure Virtual Ethernet LPAR to LPAR communication

A Virtual LAN helps speed internal communication between partitions at memory speeds,

without the need for communications adapters for each partition. The virtual I/O component

of IBM Virtualization Engine systems technologies allows the sharing of expensive devices

such as SCSI or Fibre Channel attached storage and networking communications adapters

helping to simplify system administration and drive down system and administrative

expense. Multiple VLANS in one system allow for high availability, and the ability to

provide hosted routing to networks outside the system.

•

Inter-partition communication support

•

IP forwarding provided by I/O Server partition

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Pas de commentaire

Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Manuel d'utilisateur Page 45