Red Hat NETWORK 3.6 - Guide de l'utilisateur télécharger pdf (Page 9)

Unless otherwise noted, perform all commands as the system’s root user.

Install the PVS software for Red Hat with the following command. Note that the specific

filename will vary, depending on your version:

# rpm -ivh pvs-x.x-es3.i386.rpm

Preparing... ###################################[100%]

1:pvs ###################################[100%]

[*] PVS and PVS Proxy have been installed with default configuration files

[*] Any configuration files from previous installations have been retained

[*] You may now run the post-install script at /opt/pvs/bin/pvs-post-

install.sh

The installation will create the directory /opt/pvs that contains the PVS software.

Run the Installation Script

The following is an example of running the installation script that configures the PVS. The

commands entered by the user are shown in boldface and are example answers to the

prompts. Your actual responses may vary. Additional configuration tuning may be

performed after the initial configuration by editing the /opt/pvs/etc/pvs.conf file. A

summary of the configuration options may be found in the “Configuration” section later in this

document.

# /opt/pvs/bin/pvs-post-install.sh

The screen will clear and display the following:

--------------------------------------------------------------------------

PVS INSTALLATION SCRIPT

--------------------------------------------------------------------------

TENABLE NETWORK SECURITY

http://www.tenable.com

Welcome to the PVS configuration script !

This script will help you configure your PVS installation on your system.

Press ENTER to continue

After pressing “ENTER”, the following is displayed:

Was the installation you performed with the RPM a fresh install (i) or an

upgrade (u) of PVS ? [i] i

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 60 61

Pas de commentaire

Red Hat NETWORK 3.6 - Guide de l'utilisateur Page 9