Red Hat ENTERPRISE VIRTUALIZATION FOR DESKTOPS Guide d'installation télécharger pdf (Page 11)

Quick Start

3.0. Follow the instructions in the email from Leostream you received when you downloaded the

Connection Broker from the Red Hat MarketPlace to update your Connection Broker to version 7.8

10. Click the link in the third step to skip the update and go to the Getting Started page, shown in the

following figure. This page lists the general steps required to configure your Connection Broker.

You can change your default Connection Broker password, as follows.

1. Click the Users tab in the main navigation menu.

2. Click the My Options tab in the Users page navigation menu.

3. Enter your new password in the Password and Re-type password edit fields.

4. Click Save.

The Connection Broker cannot remind you of your password. If you forget your administrator password,

you must reset it using the Connection Broker virtual machine console. Please contact

supportsite@leostream.com for instructions.

Step 4: Configuring the Network

By default, the Connection Broker uses DHCP to determine its IP address. Leostream recommends using a

static IP address for the appliance, and configuring DNS with your primary search domain. Otherwise, if

your DHCP has a short lease time, your Connection Broker IP address may time-out and your end users may

not be able to log in.

You setup a static IP address for the Connection Broker and configure the DNS, as follows.

1. Click the System tab in the main navigation menu.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Pas de commentaire

Red Hat ENTERPRISE VIRTUALIZATION FOR DESKTOPS Guide d'installation Page 11