Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guide d'installation télécharger pdf (Page 45)

Updating adm.conf . . .

Updating admpw . . .

Registering admin server with the configuration directory server . . .

Updating adm.conf with information from configuration directory server . . .

Updating the configuration for the httpd engine . . .

Restarting admin server . . .

The admin server was successfully started.

Admin server was successfully reconfigured and started.

Exiting . . .

Log file is '/tmp/setup0C7tiV.log'

The setup-ds-admin.pl script applies all default options for the Directory Server configuration,

including the instance name (for example, ldap.example.com), domain (for example,

example.com), suffix (for example, dc=example, dc=com), and port numbers (389 for the

Directory Server instance and 9830 for the Administration Server).

When the setup-ds-admin.pl script is done, then the Directory Server is configured and

running. To log into the Directory Server Console to begin setting up your directory service, do

the following:

1. Get the Administration Server port number from the Listen parameter in the console.conf

configuration file.

grep \^Listen /etc/dirsrv/admin-serv/console.conf

Listen 0.0.0.0:9830

2. Using the Administration Server port number, launch the Console.

/usr/bin/redhat-idm-console -a http://localhost:9830

NOTE

If you do not pass the Administration Server port number with the

redhat-idm-console command, then you are prompted for it at the Console

4. Typical Setup

The typical setup process is the most commonly-used setup process. It offers control over the

Typical Setup

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 153 154

Pas de commentaire

Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guide d'installation Page 45