Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guide d'installation télécharger pdf (Page 93)

RootDNPwd= password123

[admin]

Port= 9830

ServerIpAddress= 111.11.11.11

ServerAdminID= admin

ServerAdminPwd= admin

NOTE

There are three sections of directives in the .inf file to create the default

Directory and Administration Servers: [General], [slapd], and [admin].

Creating an additional instance, or installing a single instance of Directory Server

using setup-ds.pl, only requires two sections, [General] and [slapd].

This parameters correspond to the information supplied during a typical setup. The .inf file

directives are described more in Section 3.5.1, “.inf File Directives”.

3. Run the setup-ds-admin script with the -s and -f options.

/usr/sbin/setup-ds-admin.pl -s -f /export/ds-inf/setup.inf

Running setup-ds-admin installs both the Directory Server instance and the Administration

Server instance. This means that the setup file must specify parameters for both the

Directory Server and the Administration Server. -s runs the script in silent mode, and -f

/export/ds-inf/setup.inf specifies the setup file to use.

After the script runs, the new Directory Server and Administration Server instances are

configured and running, as with a standard setup.

3.2. Silent Directory Server Instance Creation

Like setting up both the Directory Server and Administration Server, silent setup for a single

instance is useful for configuring multiple instances quickly. Silent setup uses the same scripts

that are used to create a new instances of Directory Server, with a special option signaling that

the script is to be run silently and referencing the setup file to use.

To run a silent setup of a Directory Server instance, do the following:

NOTE

When creating a single instance of Directory Server, the Directory Server

setup-ds

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 153 154

Pas de commentaire

Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guide d'installation Page 93