Red Hat NETWORK PROXY SERVER 4.0 - Guide d'installation télécharger pdf (Page 212)

212  Websense Installation Guide

Chapter 5: Initial Setup

2. Locate the obj.conf file on the Sun Java System Web Proxy Server

machine. This file is located in the

/config subdirectory in the directory

where the Sun Java System Web Proxy Server was installed.

3. Make a backup copy of the

obj.conf file.

4. Open the

obj.conf file in a text editor and remove the comment

indicator (#) before every occurrence of each of the following lines:

AuthTrans fn="proxy-auth" auth-type="basic"

dbm="default"

PathCheck fn="require-proxy-auth" auth-type="basic"

realm="enter password"

5. Save and close the obj.conf file.

6. Restart the Sun Java System Web Proxy Server.

SOCKS Proxy Servers

Websense software filters HTTP, HTTPS, and FTP requests sent to the Sun

Java System Web Proxy Server, but cannot filter traffic tunneled over a

SOCKS proxy server. To use Websense filtering in a network that uses a

SOCKS proxy server, select one of the following options:

 Disable the SOCKS service.

 Through the SOCKS proxy client, disable the specific protocols that you

want the Websense software to filter (HTTP, HTTPS, and FTP), then

configure your browser to point to the Sun Java System Web Proxy

Note

See the Sun Java System Web Proxy Server Configuration

File Reference for detailed information about the

AuthTrans and PathCheck directives and their

parameters. This document is available from the Sun

documentation website at http://docs.sun.com/

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 249 250

Pas de commentaire

Red Hat NETWORK PROXY SERVER 4.0 - Guide d'installation Page 212