Red Hat NETSCAPE ENTERPRISE SERVER 6.0 - PROGRAMMER GUIDE TO SERVLETS Guide de l'utilisateur télécharger pdf (Page 181)

Configuring Certificate Settings

7-17

Configuring Certificate Settings

After configuring the Interstage certificate environment, you need to make the settings for users of the

certificate. This section describes how to do this.

1. Defining the use of certificates.

2. Setting up various service environments.

Defining the Use of Certificates

The certificates registered in the Interstage Certificate Environment can be referenced by selecting

[System] > [Security] > [Certificates] > [CA certificates], or [System] > [Security] > [Certificates] > [Site

certificates] from the Interstage Management Console.

Check whether the contents of the obtained certificates are correct.

If SSL communication is to be used, an SSL definition must be created. Create an SSL definition by

selecting [System] > [Security] > [SSL] > [Create a new SSL Configuration] tab from the Interstage

Management Console.

Each certificate has a term of validity. Check this because system operation and functions may be

stopped if the validity term of a certificate expires. It is necessary to obtain a new certificate before

expiration. Refer to Certificate Management for more information.

Setting Up Various Service Environments

Environment setup (via the Interstage Management Console) is required for each service using SSL.

The option of Interstage Management Console window used for setting each service environment is

shown below.

• Interstage HTTP Server

[System] > [Services] > [Web Server] > [Web Server Settings] tab > [Detailed Settings [Show]] > [SSL

Settings].

To use SSL on the Virtual Host, you need to set up SSL on the following screens:

− When you create a new virtual host

[System] > [Services] > [Web Server] > [Virtual Hosts] > [Create a new Virtual Host]tab >

[Detailed Settings [Show]] > [SSL Settings].

− When you update the virtual host configuration setting

[System] > [Services] > [Web Server] > [Virtual Hosts] > [(Virtual Host name)] > [Detailed

Settings [Show]] > [SSL Settings].

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 327 328

Pas de commentaire

Red Hat NETSCAPE ENTERPRISE SERVER 6.0 - PROGRAMMER GUIDE TO SERVLETS Guide de l'utilisateur Page 181