Red Hat NETSCAPE MANAGEMENT SYSTEM 6.0 - AGENT GUIDE Manuel d'utilisateur télécharger pdf (Page 13)

Dell KACE K1000 Systems Management Appliance, Version 6.0, Release Notes 13

Upgrading Agent software on managed devices

To take advantage of the many device-management features available in version 6.0 of the K1000 server,

Agent software on managed devices must be upgraded. By default, the K1000 appliance checks with Dell

KACE for Agent software updates at approximately 03:40 every day. In addition, the K1000 appliance checks

with Dell KACE for Agent updates whenever the appliance is rebooted. When Agent updates are available,

they are automatically downloaded to the K1000 appliance, provided that the appliance is connected to the

Internet at that time.

Viewing Agent software updates

When an Agent update is available, an alert appears on the Home page of the K1000 Administrator Console.

To view more information about the update, click the link in the Alert, or follow the instructions in this section.

Procedure

1. Log in to the K1000 Administrator Console and go to the appliance Control Panel:

• If the Organization component is not enabled on the appliance: Log in to the K1000 adminui:

http://<K1000_hostname>/admin, then click Settings.

• If the Organization component is enabled on the appliance: Log in to the K1000 systemui: http://

<K1000_hostname>/system, or select System in the drop-down list in the top-right corner of the

page, then click Settings.

2. On the left navigation bar, click Appliance Updates.

The Appliance Updates page appears. The current Agent bundle appears in the Agent section.

3. (Optional) To check for updates: In the Agent section, click Check for Update.

The appliance checks for updates, and the results appear on the Logs page.

Loading Agent updates and configuring update settings

You load Agent updates to the K1000 server as described in this section. After you have loaded the Agent

updates, they become available for installation on managed devices. If you have multiple organizations, you

load Agent updates and configure update settings for each organization separately.

Procedure

1. Log in to the K1000 Administrator Console.

2. If applicable, select an organization in the drop-down list in the top-right corner of the page.

3. Click Settings > Provisioning.

The Provisioning panel appears.

Agent-managed devices must have Agent version 5.5 GA or higher installed

before they can be updated to Agent version 6.0. You cannot update managed

devices from other versions directly to version 6.0.

The instructions in this section assume that the K1000 appliance has been

updated to version 6.0. Instructions for previous versions are available in the

K1000 Administrator Guide, http://www.kace.com/support/resources/

documentation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Pas de commentaire

Red Hat NETSCAPE MANAGEMENT SYSTEM 6.0 - AGENT GUIDE Manuel d'utilisateur Page 13