Red Hat Server tc3100 Guide de l'utilisateur télécharger pdf (Page 74)

74 Installation

Step 5: Set DIP Switches

BCCs are shipped from the factory with all DIP switches (see Figure 43) in the

“|” position. The pull-out label on top of the disk system identifies each switch

position.

Caution DIP Switch settings must be the same on both BCCs. If settings

differ, the disk system will fail its power-on self-test and the disks

will not be accessible through the second BCC.

Set dip switches as needed. See Chapter 3, Configuration, for switch definitions

and guidelines.

There is a switch bank that is recessed from the BCC bulkhead. Typically, they

do not need to be reset. The BCC must be removed from the disk system to

access this switch bank. See switch bank 2 in Chapter 3. Also see Tables 33 and

34 for switch settings and usage.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 157 158

Pas de commentaire

Red Hat Server tc3100 Guide de l'utilisateur Page 74